Recovering

As an added service to our customers, Universal Urethane can also take a roll straight out of a service line and return it to you ready to install. The following is a typical procedure for a complete rebuild of a roll:

Remove, clean, and straighten frames.
Remove bearings, housings, and seals. The housings are inspected and repaired if needed.
Completely inspect roll and shaft. Ultrasonic and Wet mag particle test roll and shaft. Any needed repairs are quoted at this time. A report is supplied for the UT/Wet Mag testing.
Recover your roll and finish per print.
Replace bearings, seals, and housings. Bearings and seals are supplied new or reconditioned.
Replace the frames.

The roll is now ready to be replaced into service without added cost or time incurred by your employees.