Address:
410 First Street, Toledo, Ohio 43605
Contact:
419-693-7400
419-693-2363 (fax)
sales@universalurethane.com
We can reverse engineer or prototype anything.
Machined – Molded – Stamped – Die Cut – Formed – Assembled
Most Prototypes can be developed and made quickly and at a relatively low cost. We can start with your sketch, drawing, mockup or sample. Prototype parts and assemblies may be rotating seals, reciprocating seals, three-dimensional molded shapes or flat cut gaskets. We can offer prototype samples for your inspection and approval before production. Small and large production runs are not a problem.
One reason there is a need for reverse engineering is the need to replace parts that are obsolete and no longer available from the original manufacturer or are worn and broken. Cost is another factor. Some OEMs consider some parts proprietary and make the cost very expensive, the fact being they are not proprietary. An older piece of equipment may have improved or added performance when new materials and designs are used by re-engineering a part or kit. An original sample, if available, is used to re-engineer the part. We use the sample for measurements, material analysis, and make a drawing if necessary. All kits are taken apart and each part is individually treated as above. When the parts are made, we label, package and deliver them. A 25 to 55 percent savings is often achieved (over OEM prices) through reverse engineering or re-engineering. Fast turnaround of your parts is a priority. We can stock and warehouse parts for items that are used monthly as an option for prompt delivery.
Address:
410 First Street, Toledo, Ohio 43605
Contact:
419-693-7400
419-693-2363 (fax)
sales@universalurethane.com